Category:Wilson II
Wilson II is a reprap design based on the Wilson TS.
In comparison to the Wilson TS, the changes with Wilson II are:
- The smooth rods are all 10mm (vs 8mm)
- The upright frame consists of 7 aluminum extrusions instead of 4.
- The default build volume is intended for a 20x30cm print bed vs 20x20cm, although the design is still parametric so either can be used.
- The Z axis uses lead screws (8mm diameter) instead of 5mm threaded rod.
- As a result of all of the above changes, the rod-to-rod spacing is not identical to the Prusa i3.
- Most of the plastic parts have been redesigned for both style and functional improvements, including power supply mounting brackets for the frame and slide-on brackets for SMART LCD and filament mounts.
Pages in category "Wilson II"
The following 2 pages are in this category, out of 2 total.